Roofing estimate app
Re-roof estimates from a roof report in a few minutes
Copy the totals from your roof report, or measure each plane by hand, and BidRidge works out squares, waste, starter, ice barrier, drip edge, ridge cap and flashing, then prices tear-off, materials and labor from your rates.
Free for 14 days, no card needed · then $49.99/mo or $599 once · Works on Android, iPhone and iPad, Windows, Mac, Linux and any browser
What it prices
- Architectural and 3-tab shingles, standing seam and ribbed metal, and low-slope TPO on the same roof
- Tear-off by layer, dumpsters, deck repair, re-nailing and plank-deck overlays
- Synthetic and high-temp underlayment, ice barrier at eaves and valleys, drip edge, starter and hip and ridge cap
- Step, counter and kick-out flashing, pipe boots, vents, ridge vent, chimneys and skylights
Every number comes from your own wages, production rates, material prices, overhead and margin. Pick your state and city in setup and BidRidge loads regional starting rates while you enter yours.
Draw it first: the Roofing & Siding Designer draws the roof, lays out metal panels with a cut list and matching trims, prints a drawing set and sends every length to this quote. Tap Design it on the job.
Construction details: the Roofing & Siding Designer draws a detail for each flashing on the schedule (drip edge, valleys, step flashing and kick-outs, headwall, chimney and cricket, pipe boots, metal roof trims) with this job's metal, gauge and leg sizes. Typical details from this job's numbers, not engineered: verify them with your building department and the maker's instructions.

See it in under a minute
Measured the way roofers measure
- Roof report totals: area, pitch, eaves, rakes, ridges, hips, valleys and step flashing
- No report? One card per plane: eave length, run and pitch
- Pitch, height, how cut up the roof is and the season adjust the labor
- A check flags a roof entered both ways, so nothing is counted twice
From bid to the roof
- Good, Better and Best for shingle lines, underlayment and warranty
- Extras only when the job has them: gutters, heat cable, skylights, fascia repair, snow clearing
- A Selections sheet for shingle color, drip edge and vents the customer approves
- A job pack with bundles, rolls and pieces to order
Questions
Can I use my EagleView or Hover report?
Yes. Tap Roof report totals and type the numbers from the report's summary page. BidRidge figures squares, waste and every accessory from them.
Does it price metal and flat roofs?
Yes. Standing seam, exposed-fastener ribbed metal and low-slope TPO membrane are roofing types, each with its own underlayment, trim and labor. One job can mix them.
How does pitch change the price?
Steep roofs get a labor factor you control, and each plane or report carries its own pitch, so a 12/12 front and a 4/12 porch price differently.
More from BidRidge
Try it free for 14 days
No card needed. Then $49.99 a month or $599 once, for up to 5 phones and computers. Your jobs stay yours.
Who built this
Built by a working contractor
BidRidge started as a working contractor's own estimating workbooks. The rates, production numbers and paperwork in it come from bidding real jobs.