Membranes · tapered insulation · drains · Division 07

Low-Slope Roofing Designer

Selected

Checks

    What the checks look at

    Slope: each area's slope (tapered insulation or the structure) against the minimum design slope of its membrane (IBC 2021 1507.10.1 built-up, 1507.11.1 modified bitumen, 1507.12.1 single-ply, 1507.14.1 liquid-applied), with the reroof exception of 1512.1. Drainage: a drain, scupper or gutter edge in each area; overflow drains or scuppers where parapets or walls would trap water (1502.2); the flow at your rainfall rate (the area plus half of a wall above it) against the drains' leader capacity and the scuppers' weir flow (IPC chapter 11 as adopted), scuppers 4 in. min. (1502.3). Edge metal: a tested edge system (1504.6, ANSI/SPRI ES-1). Insulation: the average R (tapered layers at their average thickness) against IECC 2021 Table C402.1.3 for your climate zone, and 1 in. at the drains (C402.2.1.2). Crickets on curbs over 30 in. across the slope (1503.5). Recover: not over two roofs or a wet one (1512.2.1.1). Wind: the zone width, your design pressures against the system's listed rating. Fire classification: your entries. Checks and flags, not an engineered design or a plan review: the engineer, the building department and the project documents govern.

    Tapered insulation by mark

    Panel marks A, B, C... a row every panel width along the slope

    Insulation assemblies

    Average R with the tapered layers at their average thickness

    Drains and scuppers

    Curbs

    Crickets on the upslope side

    Edges and sheet metal

    Coatings and spray foam

    Gallons from the dry film and the solids

    Existing roof survey

    Core cuts and wet areas

    Attachment by zone

    The maker's rates for the listed assembly; typical here

    Buy list

    Generic products at your prices; install hours
    The BidRidge quote prices these quantities on its Roofing lines at the job's wage basis.

    Send to BidRidge

    Makes a Roofing template: one row a roof area and every quantity of the buy list on the Roofing trade's "Low-slope (commercial)" lines (membrane by system, insulation, flashing, sheet metal, drains, curbs, safety, warranty, tests). BidRidge prices them from its own Roofing rate book (set your prices there once); the hours price at the job's wage basis (commercial wages, the project management, submittal and bond lines of a commercial job).

    Drawing set

    Vector PDF with a title block
    The Submittal set: the kit title block, a cover with the sheet index, the product data log (07 22 00, 07 54 23, 07 52 00, 07 62 00, 07 71 00 ...), every text 3/32". Full set (the sheet size below; ARCH D unless Arch C) or 11x17 shop sheets. The BidRidge template keeps the drawing set.

    Save & export

    The project also saves in this browser as you work. Import takes a Roofing & Siding Designer commercial project file (.roofing.json): its flat-roofed sections become roof areas at their heights, with parapets when the project has them.